Filter
Top Products
99
Additional Information
Recording does not start immediately after you
press z REC.
, Operate the recorder only after “LOAD”,
“FORMAT,” or “INFOWRITE” disappears
from the front panel display.
Nothing was recorded even though you set the
timer setting correctly.
, There was a power failure during recording.
, The recorder’s internal clock stopped due to a
power failure that lasted for more than one hour.
Reset the clock (page 86).
, The channel was hidden after the timer recording
was set. (See “To customize the channel line-up”
on page 36.)
, Disconnect the AC power cord from the AC
outlet, and connect it again.
, The program contains copy protection signals
that restrict copying.
, The timer setting overlapped another setting that
was set later.
, There is no DVD inside the recorder.
, There is not enough HDD or DVD disc space for
the recording.
, The set top box was turned off.
, The set top box controller was incorrectly
connected (page 13).
, The settings in “Set Top Box Control” in Settings
Setup have been changed (page 86).
, A separate recording was in the process of being
made without the use of the timer (page 50).
, The recorder was in the process of dubbing
(HDDyDVD).
, The recorder was in the process of DV/Digital8
Dubbing.
Recording does not stop immediately after you
press x REC STOP.
, It will take a few seconds for the recorder to input
disc data before recording can stop.
Recording does not stop after you press x
STOP.
, Open the remote’s cover and press x REC
STOP.
Timer recording is not complete or did not start
from the beginning.
, There was a power failure during recording.
Should the power failure continue for more than
one hour, reset the clock (page 86).
, There is not enough HDD or DVD disc space for
the recording.
Contents previously recorded were erased.
, Data that has been recorded on a DVD with a PC
will be erased from the disc when the disc is
inserted.
, “Auto Title Erase” in Features Setup is set to
“On” (page 93).
Display
The clock has stopped.
, Set the clock again (page 86).
, The clock stopped due to a power failure that
lasted for more than one hour. Reset the clock
(page 86).
The clock is wrong.
, Set the clock again (page 86). If you cannot
select “Clock” from “Settings” in the Setup
Display, wait until the clock data is received and
the clock is automatically adjusted.
The TIMER REC indicator is flashing.
, The disc does not have enough space.
, Insert a recordable disc inside the recorder.
The recording mode indication is incorrect.
, When the recording or dubbing is less than three
minutes, the recording mode indication may be
displayed incorrectly. The actual recording itself
is correctly made in the selected recording mode.
The clock does not appear in the front panel
display.
, “Dimmer” in Options Setup is set to “Power
Save” (page 94).
Remote control
The remote does not function.
, Batteries are weak.
, The remote is too far from the recorder.
, The remote’s manufacturer code returned to the
default setting when you replaced the batteries.
Reset the code (page 21).
, Turn on the recorder.
, The remote is not pointed at the remote sensor on
the recorder.
, Different command modes are set for the
recorder and remote. Set the same command
mode (page 23).
,continued