Filter
Top Products
19
Hookups and Settings
A Connecting to audio/video input
jacks
If your TV, monitor, projector, or other equipment
has audio/video (A/V) input jacks, you will get
better picture and sound if you connect the
recorder using this connection.
B Connecting to an antenna input
jack
If your TV does not have audio/video (A/V) input
jack, connect the recorder to a TV using an
antenna cable.
Setting the RF Output channel
When connecting the recorder to the TV using
only the antenna cable, you must set the RF
Output channel in the “Tuner Preset” so that the
TV can receive the correct signal from the
recorder.
1 Press "/1 to turn on the recorder.
2 Press TV/VIDEO repeatedly until “TV”
disappears from the front panel display.
3 Turn on your TV and set it to the channel 3.
When using channel 4 to receive the recorder
signal, see “3, 4 Ch Out” on page 98.
Yellow
White (L)
Red (R)
Yellow
White (L)
Red (R)
TV/VIDEO
"/1
,continued