Filter
Top Products
22
Operating Instructions
Inserting and Removing a CableCARD™ Device
Inserting a CableCARD device
1 Remove tape and insert the CableCARD into the CableCARD slot on the HD DVR.
2 Gently push the card into the slot until it clicks into place.
For more information about using CableCARD and activation, see “Activating CableCARD Service”
on page 26.
Removing a CableCARD device
In the event you want to cancel your service, contact your cable TV service provider.
1 Turn off the HD DVR.
2 Push the eject button on the HD DVR’s CableCARD slot to release the card.
3 Pull CableCARD straight out of the slot to remove it.
To install a different CableCARD, follow the instructions in “Activating CableCARD Service”
on page 26.
✍ Do not remove the tape covering the CableCARD slot until you are ready to insert the card. This will
prevent any foreign objects from entering into the CableCARD slot. If you use a CableCARD, keep the
card inserted in the slot at all times.
✍ Once a CableCARD device is removed, your HD DVR will no longer decrypt digital cable TV
programming services that require a CableCARD device.
✍ If you will no longer use CableCARD services, you may need to adjust the cable TV service level or
edit the channels you receive in the TV Guide On Screen™ Setup menu, see page 69.
✍ Always press the "Eject button" to remove the card from the slot. Never pull out the card without
first pressing the "Eject button." Before reinserting the card, be sure to press the "Eject button"
again. This will prepare the CableCARD slot to properly accept the card without damaging either the
CableCARD device or the slot. Do not allow the card to tilt at an angle during insertion. Be sure to
insert the card straight into the slot.