Filter
Top Products
60
6.6.10. Automatic Alternation Mode
Select “Display Division Rotation Dwell Time” and select alternation time by
sliding the selection bar. Automatic alternation mode displays images from
each camera in rotation according to the selected options on the current
recording screen.
For example, to set Automatic Alternation Mode when 4 cameras from 1 to 4
have been installed,
1. Select a desired split-screen mode from the recording display mode
(choose 1-screen mode).
2. Select the camera sequence of the 4 cameras. Set the cameras into 4
sets like 1
→2→3→4. First, select camera 1 with the mouse. Then, the
camera 1 will change in color.
3. Click [Add] button.
4. Secondly, select camera number 2.
5. Click [Add] button.
6. Thirdly, select camera number 3.
7. Click [Add] button.
8. As the method above, set the camera number 4 and add in the “Display
Sequence”.
9. Select “Display Division Rotation Dwell Time”.
10. Set the alternation time to 3 seconds by using the slide bar.
11. Click [Close] button to close the Setup box.
Now, the DVR current recording screen mode will change to a 1-screen mode.
The first set of camera “1” is displayed on the screen followed by the next set
of camera “2” in 3 seconds. The third set camera “3” is respectively displayed
in 3-seconds intervals. Lastly, the fourth set camera “4” after 3 seconds. This
shows that the 4 sets of 4 cameras are displayed on the current recording
screens at a 3 seconds interval.