Filter
Top Products
43
Playback
Recording
Editing
Function setup
Others
Introduction
Library
1:00pm 1:54pm
1:20pm
20 minutes
extend
Time Shift
2:14pm
Shifting a time period of a recording (Time
Shift)
If a prior TV program extends beyond its scheduled
time and into one that you programmed, you can shift
the programmed start and end time of the recording.
1) Press REC MENU.
The REC MENU appears.
2) Press
/ to select a timer program you want
to shift the time period.
3) Open the lid of the remote control and press
EXTEND.
“Start time” and “End time” are ready to be input.
4) Press EXTEND repeatedly.
Each time you press the button, “Start time” and
“End time” is shifted in 10 minutes intervals to, up
to 60 minutes later.
5) Press ENTER.
6) Press REC MENU to exit.
Note
• After you shifted the time of a timer program which will be
repeated daily or weekly, you should restore the original
start/stop time for future recordings.
Adding a timer program
1) Press REC MENU.
The REC MENU appears.
2) Press
to select a blank line, then press
ENTER.
3) Press
/ to select the item, then press
ADJUST to set the item.
4) When complete, press ENTER.
5) Press REC MENU to exit.
Note
• While the recorder is preparing for or executing a
programmed recording, you cannot add a timer program
which will start within 5 minutes and 15 seconds from the
current time.
Deleting a timer program
1) Press REC MENU.
The REC MENU appears.
2) Press
/ to select a timer program you want
to delete.
3) Press QUICK MENU.
The Quick Menu appears.
4) Press
/ to select “Program cancel”, then
press ENTER.
Check the message, then delete the entry.
5) Press REC MENU to exit.
Note
• You cannot delete a timer program while another is
executed.
Correcting a timer program
1) Press REC MENU.
The REC MENU appears.
2) Press
/ to select a timer program you want
to change, then press ENTER.
3) Press
/ to select an item, then press
ADJUST to set the item.
4) Press ENTER.
The modification is registered.
5) Press REC MENU to exit.
Important
• You cannot correct a timer program within 5 minutes before
the recording start time. You can only delete the timer
program.
Note
• You can program a timer recording whose start time has
already passed, unless the another program recording will
start within 5 minutes. The portion of the program before
the recording starts cannot be saved.
e.g.