Toshiba D-KR2SU DVD VCR Combo User Manual


 
138
Before calling service personnel
If you experience any of the following difficulties while using this unit, check the list below before consulting your
nearest Toshiba dealer.
Others
Power
The power is not turned on.
The power cord is not connected securely.
Connect the power cord securely.
Connection to your TV
There is no TV picture.
The video cable to this recorder and your TV is not
connected securely.
Connect the video cable to this recorder and your
TV securely.
The input select on your TV is not set property.
Select the input to which this recorder is
connected.
TV reception
There is no picture.
The antenna cable is not connected securely.
Reconnect the antenna cable securely.
There is poor reception.
Channel settings are not completed.
Set the channels.
The antenna cable is not connected securely.
Reconnect the antenna cable securely.
Antenna signal is poor.
Consult your dealer for adjustment.
Playback
A DVD or CD does not play.
The format of the recorded data does not correspond
to this recorder, or the region number is neither 1
nor ALL.
Check the disc.
A defective or dirty disc is inside.
Change the disc.
During playback, picture noise appears.
Picture noise may appear in the following cases. It is
not a malfunction.
There is picture noise in the original recording.
Weather, reception conditions may cause noise.
The data transmission rate is set to low.
The image data processing of this recorder cannot
follow dynamic movement on the screen. (Low
video data rate)
A physical error has occured on the DVD disc.
If an error occurs during reading data of a disc,
block-noises may be produced there. Repeated
reading of this location where the error occurred
(retry) can decrease the generation of block noise.
However, it can also raise the possibility of
unintended delays or stops of playback. In order to
prevent them, the recorder limits the number of times
of retry.