Filter
Top Products
Acutime 2000 Synchronization Kit User Guide 6-17
6 NTP Software Installation and Configuration
6.6.2 Manual Installation
Manual installation requires the user to create the configuration file,
copy the NTP executable to the appropriate location on disk, and then
install, configure and start the NTP service.
The manual installation procedures for the NTP software are below.
Create the Configuration File
The NTP configuration file,
NTP.CONF, should be created in the
\
WINNT\ directory.
The lines preceded by # symbols are comments and are ignored by
NTP.
Valid unit numbers on Windows NT are 1–255. The unit number
identifies the number of the serial port on the Windows NT host. For
example, if the Acutime NTP reference clock is connected to COM2,
the entry line should read:
server 127.127.29.2
1. Copy the sample configuration file above.
2. Change the Acutime unit number to the correct number
corresponding to the COM port you are using.