Filter
Top Products
MCX-2000 Owner’s Manual
33
Preparation on Each Client
1 Turn on the client.
The front panel display lights up, showing the initial screen, followed by a “Connecting...” message.
n If the client display shows the current time without backlight, it’s in sleep mode. If this is the case, press the center stick of the cursor controller.
The client wakes up and shows the above message.
2 The “Connecting...” message indicates the client is searching a MusicCAST server to establish a network connection.
At this point, however, we have not completed any network configuration. So, when the client display shows a network
icon, push the controller stick upward or downward to cancel the message. The client stops searching.
n The wireless network icon doesn’t appear on the MCX-C15 that supports only wired networking.
3 From Top Menu, select Setup > Network > Manual Setup > DHCP. Make sure the DHCP is enabled (ON).
4 Push the controller stick leftward twice to go back to the Network screen. Select Auto Configuration (Top Menu >
Setup > Network > Auto Configuration).
With this screen shown on each client, you can start automatic configuration of a MusicCAST network.
wireless network icon (no signal) wired network icon (disconnected)
DHCP ON is selected (factory setting)