Filter
Top Products
MCX-2000 Owner’s Manual
40
Mode
Specify how this client can connect to a MusicCAST network. With Wireless, its wireless network port is only enabled,
disabling its wired (Ethernet) network port. With Auto, the client connects to the MCX-2000 via either active network port
(factory setting). When using the wireless port, the ESS ID and WEP Key parameters should be configured according to
the target MCX-2000 server.
When you select and determine a value, the “Press PLAY to system restart, STOP to cancel.” message is shown. If you
press the front panel Play button, the client will restart to enable the change. Press the front panel Stop button to abort
your change. Push the controller stick leftward to go back to the Manual Setup menu.
n Wired-only clients (MCX-C15) don’t have this parameter.
Server ID
Specify the target MCX-2000 with its ID (SV-XXXXX: a 5-digit unique number to each server). You can confirm the
MCX-2000 server ID on your TV monitor, by selecting Top Menu > Setup > Network > Client Configuration > Manual
Configuration. You can also confirm client IDs in the MCX-2000 screen if you previously performed the automatic
registration (page 34). Client IDs will be required later in manual registration process (page 43), so it’s recommended to
write them down in your setup chart (page 36) at this point.
When you have finished, select and determine Save & Network Restart. When the “Please wait.” message is shown and
your setting is stored, you will go back to the Manual Setup menu. If you abort your change, select Cancel or push the
controller stick leftward.
Client IDs
Server ID