Alpine TMI-M990 Universal Remote User Manual


 
Basic Operation
18-EN
TITLE
Initial System Start-
up
Turning Power On
or Off
Opening/Closing
the Monitor
Description
When reset, the stored contents are lost. Perform storage
and adjustment one more time.
If you reset when the display is open, then the display is
automatically closed.
If you reset while the display is opening, the backlight
briefly lights up, but this is not a fault.
The power does not switch off by simply closing the display.
The TMI-M990 stores the state before the ignition key
switches off. For example, if the ignition key is switched
from OFF to ON in NAVI. mode, then the NAVI. mode is
activated.
If OPEN/CLOSE / SETUP is pressed while the display is
moving, then it stops. When it stops, press OPEN/CLOSE /
SETUP again.
The display automatically opens/closes depending on the
status of the ignition key (engine key). For the setup
operation, “Setting Automatic Opening/Closing of the
Monitor”, page 39.
The display can be opened even when the power is off, but
the power will not automatically turn on.
See “Turning Power On or Off” (page 10) to turn on the
power.
Under cold temperature conditions, the screen may lose
contrast temporarily. After a short warm-up period, it will
return to normal.
In low ambient temperature conditions, the display may be
dark for a short period of time immediately after the power
is turned on. Once the LCD has warmed up, the display
returns to normal.
Related page
Supplementary
information
This page includes supplementary information for pages 9 to 17.
Please refer to these pages.
Page 9
Page 10
Page 10
Page 12
Page 12
Page 12
Page 12
Page 9
Page 9
Page 12