Filter
Top Products
57-EN
1
IONBUS cable
Used when setting up IONBUS
compatible products.
2
IONBUS terminal
Used when setting up IONBUS
compatible products.
3
IONBUS cable (Included)
4
Power Supply Connector (Included)
5
Reverse Lead (Orange/White)
Use only when a back-up camera is
connected. Connect to the plus side of the
car's reverse lamp that lights when the
transmission is shifted into reverse (R).
Switches the video picture to the back-up
camera. This is linked with putting the car
into reverse (R).
6
Parking Brake Lead (Yellow/Blue)
Connect this lead to the power supply
side of the parking brake switch to
transmit the parking brake status signals
to the TMI-M990.
7
Foot Brake Lead (Yellow/Black)
Connect to the vehicle's foot brake lead or
brake lamp lead.
8
Switched Power Lead (Ignition)
(Red)
Connect this lead to an open terminal on
the vehicle's fuse box or another unused
power source which provides (+) 12V only
when the ignition is turned on or in the
accessory position. When connecting with
the IONBUS compatible head unit, do not
connect the ignition lead.
9
Battery Lead (Yellow)
Connect this lead to the positive (+) post
of the vehicle's battery.
p
Choke Coil with Fuse Holder (7.5A)
q
Ground Lead (Black)
Connect this lead to a good chassis
ground on the vehicle. Make sure the
connection is made to bare metal and is
securely fastened using the sheet metal
screw provided.
w
Remote Control Output Lead (White/
Brown)
Connect this lead to the remote control
input lead. This lead outputs the
controlling signals from the remote
control.
e
Remote Control Input Lead (White/
Brown)
Connect the external Alpine product to the
remote control output lead.
r
Monitor Extension Cable (Included)
t
Display Output Terminal
y RGB Input Terminal
u
S Video Input Terminal
i
AUX Input Terminals/AUX Output
Terminals
o
System Switch
Change to “1:SYSTEM” when the TMI-
M990 is connected with an IONBUS
compatible head unit.
When not connected to an IONBUS
compatible head unit, change to
“2:STANDALONE”.
• Be sure to turn the power off to the unit
before changing the switch position.