Filter
Top Products
19-EN
Related page
Description
If the monitor touches an obstacle while the angle is being
adjusted, the unit stops the screen immediately.
Should this happen, remove the obstacle and press
/ TILT or / TILT again.
The screen color will vary when viewed at certain angles.
Adjust the screen angle for the best viewing position.
If the voltage of the vehicle's battery power is low, the
screen may blink when the screen angle is changed. This is
normal and not a malfunction.
The display angle is also allowed to adjust while turning
power off.
The factory settings for the sound volume is minimum.
In the AUX mode, if you press BAND/SETUP on the
supplied remote control, you can change between AUX-1,
2, 3.
In the setup screen, etc., the display mode enters Wide
mode.
After exiting from the setup operation, the display mode
returns to the original display mode.
In the navigation screen, the display mode is not allowed to
be switched.
TITLE
Adjusting the
Monitor Viewing
Angle
Adjusting the
Volume
Switching the
Source
Switching Display
Modes