AVerMedia Technologies LX5000 DVR User Manual


 
AVerMedia LX5000 User’s Manual
9
Modem List of modems supported:
Lucent Venus Serial Voice Modem
Rockwell (Connexant) chipset Voice Modem
Topic chipset Voice Modem
Zyxel Omni56K Voice Modem
(
if a modem is to be used with in the
AVerMedia LX5000 server, it needs to be an
external modem)
SCSI Card AHA
Monitor 1024 x 768 (or higher) with horizontal frequenc
y
of 60 Hz
Mouse 3-button mouse
PTZ Camera List of PTZ cameras tested:
Lilin PIH-717/7000/7600
Dynacolor D7700
Kampro KC-7720
Pelco SD5TAC Series
AVerMedia LX5000 User’s Manual
10
Most PTZ cameras use RS-485 as the communications protocol
but most motherboards use RS-232 serial ports. If this is the
case, you need to purchase an RS-232 to RS-485 converter.
If you purchase the AVerMedia LX5000 kit, and you run out of
external COM ports for the speed dome camera, you can use a
10-pin to DB-9 ribbon cable (included with package) with the internal
COM header on the motherboard. First, plug the 10-pin connector into
the internal COM header. Then screw the DB-9 connector into the I/O
bracket (also included in the packaging). Finally use the screws to
attach the I/O bracket to your chassis. You can now connect your
speed dome cameras. See the following figure.
If you want to add an additional hard disk, please first partition
it manually following the rule of LINUX system operation. On
the other hand, note that only the CD-R with IDE interface can be
connected to IDE 1 slave.