Filter
Top Products
32 ______________________________________________ Barco - RHDM-1701 - Maintenance Manual
Removal and reinstallation of electronic boards
• The back cover is now disconnected and is ready for further maintenance
actions.
Reinstallation of the back cover
Execute all actions mentioned above in the reverse order.
Take the following points into account:
• After connecting the LVDS cables to the panel driver board, verify that the
clamps are placed over the stripped part of the LVDS cables.
Figure 12: Correct clamping of the LVDS cables
7.9 Removal and reinstallation of the power supply
Figure 13: Top view of the power supply
Removal of the power supply
• Follow the removal instructions of the back cover to remove the back cover.
• Place the back cover on the table with the inside facing up.
1
2
1
2
Stripped part of LVDS cable
Copper clamp fixation