Filter
Top Products
MV 4440_Ciprico Inc. 5-13
MediaVault 4440 User Manual Operations
Changing Modes When Hot-Plugging vPODs
In some cases the MV 4440 cannot be power-cycled, and the mode must
be changed while the vPOD is hot-plugged. Perform the following
procedure.
1. Select a mode.
2. Set the mode number with the MODE SELECT switch located on the
vPOD. See Figure 5-3. Use a pointed object (such as pen tip) to press
the desired button at the M
ODE SELECT switch.
3. Insert the vPOD into the MV 4440.
4. As soon as the OK LED illuminates, press and hold the MODE SET
button (see a description of the button on page 5-14).
5. Keep holding down the MODE SET button until two beeps are heard.
6. Release the MODE SET button.