DirecTV D10 CRT Television User Manual


 
Connections & Setup
10 Chapter 1
Chapter 1 11
Connections & Setup



















 












TV
Note:
The message “Searching for Satellite Signal”
might appear briey at the bottom of your
screen when you turn on your DIRECTV
Receiver for the rst time. This is normal.
If this message stays on the screen for more
than one minute, check your receiver’s
on-screen signal meter to make sure your
antenna is receiving the strongest possible
satellite signal. See “Test Signal Strength” on
page 26 for more information.
SELECT
button
MENU
button
EXIT
button
Arrow
buttons
INFO
button
Plug in and Turn on the Receiver
Plug the end of the power cord into the wall outlet. Be sure to insert the plug
completely.
To turn on the DIRECTV
®
Receiver, press the PWR button on the remote control
or the POWER button on the front panel. Turn on your TV.
Using Highlight and Select
All on-screen menus can be handled the same way, using highlight and select
navigation.
Highlight and select navigation has two steps:
1. Use the arrow buttons (up, down, left, and right) on the remote control to
highlight different choices on the screen.
2. Press SELECT to select the highlighted item.
Once you know how to navigate on-screen menus, you can complete the Guided
Setup (see the next step) and explore the menu system.
To display the on-screen menu system, press the remote control’s MENU button.
Note: Don’t worry about getting stuck inside a menu. Pressing the EXIT
button on the remote control takes you out of the menu system and back
to the program you were watching.
Complete the Guided Setup
If you installed your satellite dish antenna yourself, you may have already used
the Guided Setup to nd dish-pointing coordinates, acquire and ne-tune the
signal, run the phone setup, program the remote control, and run a system test.
If you need to run the setup again, you can do so from the Satellite Setup menu.
You can also check the signal strength or check dish-pointing coordinates from
this menu.
To check the signal strength, repeat the satellite dish setup, or get
dish-pointing coordinates:
1. Press MENU to access the Quick Menu.
2. Press SELECT with Settings highlighted in the Quick Menu.
3. Press SELECT with Setup highlighted in the Settings menu.
4. Use the arrow buttons to highlight Satellite in the Setup menu, and press
SELECT to select it.
5. To run the signal strength meter, highlight Test Signal Strength and press
SELECT.
To repeat the satellite dish setup, highlight Repeat Satellite Dish Setup and
press SELECT.
To check your dish-pointing coordinates, highlight Enter Lat. & Long. and
press SELECT.