Filter
Top Products
Page 33
Optimize Your Remote Controls
Attach a UHF Attenuator (for optional accessory)
Stray UHF signals can block signals sent from a remote control to the receiver.
Obtain a 10 dB attenuator (you can buy one from a consumer-electronics parts
store).
Note: This will help keep out stray UHF radio signals, but also cut down on
how far away you can use the remote control from the satellite receiver.
1. Take the UHF remote control
antenna off of the receiver’s back
panel UHF Remote Antenna
input.
2. Hand tighten the attenuator onto
the UHF Remote Antenna input.
3. Put the UHF remote control
antenna onto the attenuator.