Filter
Top Products
Chapter 3
Page 82
Using the System
Turning Caller ID On and Off
1. Press MENU 6-1-2 on the DISH Network remote control.
2. From the Caller ID screen, select either
Enable Caller ID (if it is disabled)
or the
Disable Caller ID option if you wish to disable this feature.
3. Select
Done.
Resetting Receiver to Factory Default Settings
Note: Resetting the receiver to factory-default settings discards all Favorites
Lists
except the All Chan and All Sub lists.
Note: If you have set any locks on the receiver, and the receiver is locked, then
these locks will be kept. If the receiver is unlocked, any such locks will be lost.
You cannot reset the receiver to factory-default settings to discard a password
that you have forgotten. Nobody can reset a receiver to bypass a receiver lock.
If you want to reset the DVR receiver to be the same as when it was shipped to
you from the factory, do the following:
1. Press MENU 6-6 to request the factory reset.
2. When the receiver displays a
Warning message, confirm that you want to
reset all receiver preferences by selecting
Yes.