Filter
Top Products
Chapter 3
Page 42
Using the System
• You can use the letters above the NUMBER PAD buttons while within the
Search menu. For example, when looking for the channel and event times
to watch Rudy Fremmel Presents, you press 7 three times for an R, 8 two
times for a U, 3 one time for a D, and 9 three times for a Y to spell the word
“Rudy” (see Using Themes and Search on page 71).
Star Button
Press the STAR button to:
• Open the
DVR Events menu.
• Backspace without deleting while using the
Search feature (see Search on
page 71).
Zero Button
Press the ZERO button to forward space while using the search function of your
receiver.
Pound Button
Press the POUND button to display the Search screen. Also, you can use this
button to perform several procedures in this User’s Guide.
Recover Button
Press the RECOVER button if you accidentally change the channel or video
input/source on your TV and cannot get the picture back from your satellite
receiver. When you press the RECOVER button as described below, the remote
control sends commands to your TV to change channels or video inputs to try to
return you to watching satellite programming. This procedure works only if you
have accidentally changed the TV channel or video input. It does not recover a
lost satellite signal (See Chapter 4 - Reference for troubleshooting information).
The following setup is required to use the RECOVER button:
• The remote control must be set up to control the TV and, if installed, the
VCR (see page 85).
• If a VCR is installed, make sure it is connected as shown on page 31.
To use the RECOVER button, complete the following instructions:
1. Press and hold the remote control’s RECOVER button until all four device
mode buttons light, and then release the button. The SAT mode button
flashes twice and then all four device mode buttons flash three times.
2. Press the RECOVER button. Wait for the TV or VCR mode button to flash