Filter
Top Products
Page 35
Setting Up TV1 to Operate in IR (default)
Setting Up TV1 to Operate in IR (default)
The following instructions describe how to set up TV1 to operate in IR only,
which is the default.
1. Perform the following with an existing linked remote control:
a. Open the
TV1 UHF Pro Setup screen by pressing MENU-6-1-6 on the
remote control.
b. Select
Disable from the TV1 UHF Pro Setup screen.
c. Select
System Info to open the System Information screen.
2. Perform the following with an IR remote control, such as a Remote Control
5.4 (as shown in the writing on the back of the remote), that you intend to
use to control TV1:
a. Press the RECORD button. The
Done button should be highlighted.
b. Make sure the
System Information screen shows that the Primary
Remote Address
indicates IR.