Filter
Top Products
Description of the menu options
ELSA MicroLink Cable
R103
Default-lease-
time-minute(s)
Here you can enter the period of validity that is assigned if the host makes no request.
The DEFAULT value of 500 minutes equals approximately 8 hours.
Table-DHCP
In the DCHP module, the 'Table-DCHP' option allows you to verify (or look up) the
assignment of IP addresses to the relevant computers. This table has the following
layout:
IP-address: IP address assigned
Node-IP: The computer’s Ethernet address
Timeout: Time remaining until the assignment becomes invalid
Hostname: The computer’s name in plain text if it was transmitted in the request
Type: This field contains additional information on the assignment.
The 'Type' field specifies how the address was assigned. This field can assume the
following values:
– new: The computer has made its initial request. The DHCP server verifies the
uniqueness of the address that is to be assigned to the computer.
– unkn.: While verifying uniqueness, it was determined that the address has
already been assigned to another computer. Unfortunately, the DHCP server has
no means of obtaining additional information on this computer.
– stat.: A computer has informed the DHCP server that it has a fixed IP address.
This address can no longer be used.
– dyn.: The DHCP server assigned an address to the computer.
Setup/Config-module
This menu allows you to enter settings for router configuration options. The menu has
the following layout:
IP-address Node-ID Timeout Hostname Type
10.1.1.10 00a0570308e1 500 ELSA new
/Config-module Configuration module settings
Password-required Password required on/off if there is no password
Switch-Off-mode Configuration of the On/Standby switch
Standby Standby status
Config-aging-minute(s) Time limit for remote configuration connections