Filter
Top Products
Introducing the ELSA MicroLink Cable
ELSA MicroLink Cable
7
CE conformity and FCC radiation standard
CE
This equipment has been tested and found to comply with the limits of the European
Council Directive on the approximation of the laws of the member states relating to
electromagnetic compatibility (89/336/EEC) according to EN 55022 class B and EN55024.
FCC
This equipment has been tested and found to comply with the limits for a Class B digital
device pursuant to Part 15 of the Federal Communications Commission (FCC) Rules.
Operation is subject to the following two conditions:
ᕡ This device may not cause harmful interference, and
ᕢ This device must accept any inteference received, including interference that may
cause undesired operation.
The FCC ID of this device is KJGMLCABLE.
CE and FCC
These limits are designed to provide reasonable protection against radio frequency
interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy. It may interfere with radio communications if not
installed and used in accordance with the instructions. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause
interference to radio or television reception (this can be determined by turning this
equipment off and on), the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the distance between this equipment and the receiver.
Connect the equipment to an outlet on a circuit other than that to which the receiver
is connected.
Consult your dealer or an experienced radio/TV technician.
Caution: To comply with the limits for an FCC Class B computing device, always use
a shielded signal cable.
The Federal Communications Commission warns the user that changes or modifications
to the unit not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.