Filter
Top Products
Installation and configuration
ELSA MicroLink Cable
10
English
First Steps
Give it some power
First, give your device the power it needs through the power supply unit!
Onto the net
Connect the unit to your local network using the twisted pair cable. Please check the
position of the node/hub switch: 'Node' is the correct position when connecting the unit
to a network. Switch to 'Hub' when connecting the unit directly to a workstation.
The wire to the world
Connect the
ELSA MicroLink Cable
to the TV cable network using the coaxial cable or the
adapter and a normal antenna cable. Data is transmitted through the cable TV network
in accordance with the MCNS (Multimedia Cable Network System)/DOCSIS standard.
The connection to the cable TV network must provide a certain signal level. This value
will be checked by your cable network operator and adjusted as required.
And we're off
Switch the device on at the back. The 'Power' LED on the front panel lights up after a
short self-test. The 'LAN Link' LED indicates that the unit is correctly connected to the
LAN and that the Node/Hub switch is correctly set.
If this LED is not lit, change the position of the Node/Hub switch. If the LED still does not
light up, there may be a problem with the network adapter or the cabling.
Software installation
The
ELSA LANconfig
configuration software for Windows 95, Windows 98 or Windows
NT 4.0 may be used to configure the unit as required or to set it up for other applications.
Alternatively, you can perform the configuration via telnet from any other TCP/IP capable
computer (e.g. Linux, Solaris). Install the TCP/IP network protocol, followed by the
ELSA
LANconfig
on the computer that will be used to set up the device. If the setup program
does not start up automatically after insertion of the CD, start Windows Explorer, click
on 'autorun.exe' on the
ELSA MicroLink Cable
and follow the instructions in the install
program.
Configuring the
ELSA MicroLink Cable
The first time
ELSA LANconfig
is run, the new modem is automatically detected on the
TCP/IP network and can immediately be configured.
When configuring the router with
ELSA LANconfig
, you can use the setup wizards to
quickly and conveniently guide you through the required settings.
1
2
3
4
5
6