Filter
Top Products
Setting Up the TV 19
Cable Box Unscrambles Only Some of Your Channels
If your cable box unscrambles signals for only some of your channels, connect it as follows:
1 Connect the cable coming into the house to the ANT 1 connector on the back of the TV.
2 Remove the jumper cable connected to both the RF Output and ANT 2 connectors on
the back of the TV. Retain the cable.
3 Connect one end of a coaxial cable to the RF Output connector on the back of the TV.
4 Connect the other end of the coaxial cable to the IN connector on the cable box.
If your coaxial cable has a screw-type connector on the end, secure it by turning the end
clockwise.
5 Connect another coaxial cable to the OUT connector on the cable box.
6 Connect the other end of the coaxial cable to the ANT 2 connector on the back of the
TV.
7 Be sure to turn on use of the TV’s ANT 2 port, as described on page 47.
Note
Be sure to retain the jumper
cable in case you change
your TV connections later.
You’ll need to connect it
again in certain
connection schemes to
provide the channel
zapping feature.
Wall jack
Cable box
Coaxial cables