Filter
Top Products
Panels and
Cabling
This section provides information on:
z Installation Overview
z Front Panel Features
z Rear Panel Features
Installation Overview
1. Turn off and disconnect the VNM Recorder and all existing devices.
2. Mount the recorder, if necessary, as described in the Mounting section on page 72.
3. Connect any necessary devices to the recorder (see Front Panel Features below and
Rear Panel Features on page 10).
4. Reconnect and power on all devices.
Front Panel Features
NOTE: Some features listed in this user guide may not be available on some units. This
will not affect the overall functionality of the VNM Recorder.
The front panel of the VNM Recorder is shown in figure 5.
2
1
3
4 5
6
7
Figure 5. VNM Recorder Front Panel
a
SCA / SATA drive panel — This panel houses the RAID5 hard drives. One hard drive
is referred to as a hot spare drive, which is a drive that is inactive until an active drive
fails. When an active drive fails, the hot spare drive rebuilds the data of the failed drive
so that the system can recover.
VNM Recorder • Panels and Cabling 8