Filter
Top Products
9. If changes were made, a dialog box appears asking to confirm the changes. Click Yes
to confirm and save the changes (see figure 13).
Figure 13. Confirm Settings Window
10. The following dialog box appears (see figure 14). Click OK to continue.
Figure 14. Settings Saved Window
11. A loading dialog box appears and the necessary changes are made to the system. After
the loading dialog box disappears, navigate back to the Network Configuration window
and check that the status of the eth0 device now reads Active.
12. Close the Network Configuration window.
VNM Recorder • Recorder Conguration and Hardware Setup 19