Filter
Top Products
c
Clock Management
The Current Time field displays the date and time the user interface page was served.
Use the New Time field to update the date and time. Use the following guidelines and
refer to figure 25 on the previous page when updating the date and time.
z The entry should be input in an identical format shown in the Current Time field:
year‑month‑date hours‑minutes‑seconds.
z The year should include the century (for example, 2012).
z The month is represented by a two digit number from 01 through 12.
z The date is represented by a two digit number from 01 through 31.
z Hours are represented by a 24 hour clock using two digit numbers from
00 through 23.
Click on Change Time to save the date and time entered in the New Time field.
d
Controller Licensing
CAUTION: DO NOT place information for a device license into this area. Doing
this may cause the VNM Recorder to stop responding. This area is used for
controller licenses only. See Licensed Features panel on page 29 of the
Recorder Device Page section for information about device licenses.
In addition to each device containing a device license, the VN-Matrix system also
includes a controller license. The controller license manages the number of
connections that can be made simultaneously when using the VNM Software Decoder
(part number 29-098-01).
To obtain a new controller license, follow the procedure below:
1. Contact the Extron S3 Sales and Technical Support Hotline and provide the following
information.
z The serial number of the VN‑Matrix device configured as the system
controller. This can be obtained from the back of the device.
z The order number of the VN‑Matrix device.
2. The Extron S3 Sales and Technical Support Hotline provides an options key and a
checksum.
z Enter the options key into the Options field.
z Enter the checksum into the Checksum field.
3. Click Change License to save the new license.
VN-Matrix Encoder and Decoder Conguration
The user interface pages discussed in this guide are associated with the VNM Recorder. The
VN‑Matrix encoders and decoders may need to be configured using the other pages of the
web‑based user interface for the system to operate properly. For more information on how
to configure the encoders and decoders, see the VN-Matrix 200 Series User Guide,
VN-Matrix 225 Series User Guide, VN-Matrix 300 User Guide, and the VN-Matrix 325
User Guide.
VNM Recorder • About the Web-based User Interface 42