Filter
Top Products
5. Run the installation program by typing in the following command and pressing the
<Enter> key.
./vnrecorder_install
6. A series of prompts will start to request configuration information. Use the
config.xml and the admin.xml files (see the Gathering Firmware Installation
Information section on page 64) while using the Firmware Installation Table below
to fill in the requested configuration information.
NOTES:
• The Controller options and Controller checksum prompts require an options
key and a checksum which is provided by Extron.
• If keys have been previously provided by Extron, they can be found within the
admin.xml file. See "Controller options:" and "Controller checksum:" in the
Firmware Installation Table below.
Firmware Installation Table
Prompt Value to Enter Xml File
Reference
Value
Reference
User name to run
application:
z
matrix_rec none none
Serial number:
z
Serial number of the VNM Recorder config.xml serial
Licensed Recorder
channels:
z
Check the R value (for example,
R5, P5, mR, mP, mV determines that 5 is the
necessary value).
z 5 is the default value.
config.xml structure
Recorder GUI enabled
(yes/no):
z
Check the mV value (for example,
R5, P5, mR, mP, mV).
z If mV is present, answer Yes. Otherwise, answer No.
config.xml structure
License checksum:
z
Checksum of the VNM Recorder
z Copy and paste the value
config.xml
checksum
Controller IP
address:
z
The IP address of the device acting as the system
controller
config.xml
st_controlIP
Controller port
number:
z
The controller port number
z The default value is 5432
config.xml
st_controlPort
Local IP address:
z
The IP address of the VNM Recorder config.xml
st_localIP0
Controller options:
z
This is the options key provided by Extron for use in
VNM Recorders acting as the system controller.
z If no data is provided or available, leave blank or
contact the Extron S3 Sales and Technical Support
Hotline and ask for a structure key.
admin.xml
options
Controller checksum:
z
This is the checksum provided by Extron for use in
VNM Recorders acting as the system controller.
z If no data is provided or available, leave blank or
contact the Extron S3 Sales and Technical Support
Hotline and ask for a license key.
admin.xml
checksum
Control port:
z
The controller port number
z The default value is 5432
config.xml
st_controlPort
VNM Recorder • Firmware Updates 66