HP (Hewlett-Packard) LC3700N Flat Panel Television User Manual


 
Troubleshooting
Troubleshooting 81
Remote control programming questions
Broadcast reception error messages
i.LINK cautions
A red light blinks when I press a key,
but my home entertainment equipment
does not respond.
Make sure the remote control is aimed at your home entertainment
equipment and is not farther than 16.4 feet (5 meters) away.
The selected mode button (TV, DVD,
STB, PVR, Aux, VCR, Audio, or HP)
does not blink when a button on the
remote control is pressed.
Replace the batteries with three (3) AAA non-rechargeable batteries.
Symptom Remedy
The remote control does not control
home entertainment equipment, or the
commands are not working properly.
Try all listed codes for the equipment brands being set up. Make sure they
can be operated with an infrared remote control.
Changing channels does not work
properly.
If the original remote control required pressing Select to change channels,
press Enter on the remote control after entering the channel number.
CH +, and CH – do not work for your
RCA TV.
Due to RCA design (1983–1987), only the original remote control
operate these functions.
Error Message
Error
code Possible Solution
Failed to receive broadcast. E202 Check the antenna cable. Check that the antenna is correctly set up.
No broadcast now. E203 Check the broadcast time in the program guide.
Caution Sentence Possible Solution
Record/playback may fail on the
selected model.
Displayed when you have selected a device that is not compatible with the
TV or that does not have DTLA copy protection technology installed.
Wrong connection or no i.LINK
connection was found. Refer to
User’s Guide on connection.
Displayed when a problem is experienced with a connection using i.LINK
cable. Check the connection, and reconnect the cable if necessary.
The selected model is disabled to
record/play. Check that no other
model is used.
Displayed when the device you have selected is already being used by
another i.LINK connected device. To operate the selected device from the
TV, you will first have to override control from the other device.
Symptom Remedy