Filter
Top Products
04/08 UDC3200 Universal Digital Controller Operator Manual 65
4 Monitoring and Operating the Controller
4.1 Operator Interface
Introduction
Figure 4-1 is a view of the Operator Interface.
Figure 4-1 Operator Interface
4.2 Entering a Security Code
Introduction
The level of keyboard lockout may be changed in the Set Up mode. However,
knowledge of a security code number (0 to 9999) may be required to change from one
level of lockout to another. When a controller leaves the factory, it has a security code
of 0 which permits changing from one lockout level to another without entering any
other code number.
Procedure
If you require the use of a security code, select a number from 0001 to 9999 and enter
it when the lockout level is configured as NONE. Thereafter, that selected number
must be used to change the lockout level from something other than NONE.
ATTENTION Write the number on the Configuration Record Sheet in the
configuration section so you will have a permanent record.