Filter
Top Products
66 UDC3200 Universal Digital Controller Operator Manual 04/08
Table 4-1 Procedure to Enter a Security Code
Step Operation Press Result
1
Enter Set Up
Mode
SetupSetup
Upper Display = SET UP
Lower Display = TUNING
2
Select any Set
Up Group
FunctionFunctionFunction
Upper Display = 0
Lower Display = SECUR
3
Security Code
Entry
or
To enter a four digit number in the upper display
(0001 to 9999)
This will be your security code.
4.3 Individual key lockout
There are three keys that can be disabled to prevent unauthorized changes to the
parameters associated with these keys. First set the “Lock” prompt to NONE.
These keys are:
Run
Hold
Run
Hold
Run
Hold
Key - you can disable the Run/Hold key for Set Point
Programming at configuration Set Up group prompt
“Tuning,” function prompt “RN HLD.”
Man
Auto
Man
Auto
Man
Auto
Key - you can disable the Auto/Manual key at configuration
Set Up, group prompt “Tuning”, function prompt
“AUTOMA”
SP
Select
SP
Select
SP
Select
Key - you can disable the Set Point Select function key at
configuration Set Up group prompt “Tuning,” function
prompt “SP SEL.”
See Subsection 3.3 - Tuning Parameters Set Up Group prompts to enable or disable
these keys.
Key error
When a key is pressed and the prompt “Key Error” appears in the lower display, it
will be for one of the following reasons:
• Parameter not available or locked out
• Not in setup mode, press SET UP key first
• Individual key locked out.