Filter
Top Products
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VP-747
12
6 Connecting the VP-747
The VP-747 is a universal presentation matrix switcher / scaler that lets you
choose what sources to connect to the inputs. For example, you can connect
just five sources: an RGBHV source, two DVI / HDMI sources, an HDTV
source and an RGBS source (as the example in
Figure 3 shows).
To connect
1
the VP-747 as illustrated in the example in Figure 3, do the
following:
1. Connect the following video sources:
An HDMI source to the INPUT DVI / HDMI 1 connector
An HDMI source to the INPUT DVI / HDMI 2 connector
An HDTV satellite receiver source to the R/PR, G/Y/CV, and
B/PB/C BNC INPUT 6 connectors (PR/Y/PB)
An RGBHV computer graphics source to the R/PR, G/Y/CV,
B/PB/C, HS/CS and V BNC INPUT 8 connectors (R, G, B, H, V)
2. Connect the PROGRAM OUT:
DVI / HDMI connector to the plasma display
VGA 15-pin HD connector to the analog display
R/PR, G/Y, B/PB, (PR, Y, PB) BNC OUTPUT connectors to the
YUV acceptor, for example, a projector (PR,Y, PB)
3. Connect the PREVIEW OUT R/PR, G/Y, B/PB, HS and VS BNC
OUTPUT connectors to the display (R, G, B, H, V)
4. Connect the power cord
2
5. If required, connect:
.
A PC via RS-232, see
The Kramer VP-727A Audio Switcher via the To AUDIO UNIT
RS-485 port
Section 7.1
3
, see
The Kramer VP-727T Presentation Switcher Control Panel via the
TO CONTROLLER mini XLR port
Section 7.2
3
The ETHERNET port
3
, see
Section 7.4
1 Switch OFF the power on each device before connecting it to your VP-747. After connecting your VP-747, switch on its
power and then switch on the power on each device
2 We recommend that you use only the power cord that is supplied with this machine
3 Not shown in
Figure 3 (see Section 7.3)