Filter
Top Products
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Understanding the VP-747
22
8.2.1 The Transition from Preview to Program
The transition can occur in one of two modes
1
• The Swap
:
2
mode (shown in Figure 9
), in which the PREVIEW input
buttons and the PROGRAM input buttons switch places after pressing the
TAKE button. For example, in
Figure 9 the PROGRAM input button 3
would switch to 2 and the PREVIEW input button 2 would switch to 3, so
the RGBS source is displayed on the PROGRAM screen and the
Component source is displayed on the PREVIEW screen.
• The Follow mode in which the PROGRAM input button is switched to the
same position as the PREVIEW input button after the TAKE button is
pressed
8.3 Switching/Scaling of an Input
The VP-747
scales the selected sources
3
to HDMI, RGBHV or YUV and
VGA simultaneously. It switches seamlessly between sources using the
selected special effects, which include cuts, fades, and wipes. Select the
appropriate source (from channel 1 to 8) via the Input command in both the
Preview Setting OSD screen and/or the Program Setting OSD screen (see
Section 9.1.1
), via the IR or front panel pushbuttons, or via the serial or
Ethernet control.
1 As selected via the Transition OSD Menu, see Section 9.1.2
2 Swap mode is the default for the VP-747
3 Composite video, s-Video, component video (sometimes called YUV or Y, B-Y, R-Y or Y, Pb, Pr ), RGB/YUV, RGBS,
RGsB, or RGBHV