Filter
Top Products
31
ENGLISH
Setting the Digital Audio
Output to be Compatible
with your AV Component – DVD
This player is capable of digital audio output for Dolby Digital,
DTS, MPEG, and signals with a sampling rate of 96 kHz.
Make settings in the Setup screen Audio 1 menu to reflect the
capabilities of the components that you have made digital
connections to.
Notes
• If you have already completed the Setup Navigator screen
operations, the settings on this page have already been set by
the player.
• If you have made only stereo line connections (analog) using the
supplied audio cord, it is not necessary to make any changes in
this menu.
Dolby Digital Out
This player is capable of outputting the Dolby Digital
surround sound audio signal. When the player is connected
to an AV component that has a built-in Dolby Digital decoder,
select [Dolby Digital]. This player can also convert the Dolby
Digital signal to a digital Linear PCM signal, the same digital
signal output from a CD. Select [Dolby Digital 3 PCM] when
you have made connections to an amplifier or receiver with a
Dolby Pro Logic decoder or a Digital Analog Converter
(DAC).
DTS Out
This player is capable of outputting DTS digital audio for
DVDs recorded in DTS. When this player is connected to an
AV component that has a built-in DTS decoder, select [DTS].
If your system is not equipped to decode DTS, select [Off].
Refer to the operating instructions supplied with your audio
components if you are unsure about compatibility with DTS.
Settings: Dolby Digital*
Dolby Digital 3 PCM
* Factory setting
Settings: Off*
DTS
* Factory setting
Note
If you have made digital audio connections to component(s) not
equipped to decode the DTS digital bitstream, be sure to select
[Off]. If a DTS signal is output without decoding, the output is digital
noise that could potentially cause damage to your speakers.
Settings: Down Sample On*
Down Sample Off
* Factory setting
Audio1 Audio2 GeneralLanguageVideo
DTS Out -
Linear PCM Out – Down Sample On
MPEG Ou
t – MPEG 3 PCM
Move
Exit
Dolby Digital 3 PCM
Dolby Digital
SETUP
Dolby Digital Out
Digital Out – On
Dolby Digital Out –
DTS Out
Linear PCM Out – Down Sample On
MPEG Ou
t – MPEG 3 PCM
Move
Exit
DTS
Off
Dolby Digital
SETUP
Audio1 Audio2 GeneralLanguageVideo
Digital Out – On
MPEG Ou
t - PCM
Dolby Digital Out –
DTS Out –
Linear PCM Out
Move
Exit
Down Sample Off
Down Sample On
Dolby Digital
Off
SETUP
Audio1 Audio2 GeneralLanguageVideo
Digital Out – On
Linear PCM Out
This player is capable of outputting digital signals with a
sampling frequency of 96 kHz. If you have made connections
to a component capable of processing this signal rate, select
[Down Sample Off] for the signal to be output as is. As some
components are incapable of processing digital signal input
with sampling rates of 96 kHz, selecting [Down Sample On]
compresses the signal to a standard signal with a sampling
rate of
48 kHz.
If [Digital Out] is set to [On] and [Linear PMC Out] is set to [Down
Sample On], you’ll see the message “Digital Out Converted”
appear on-screen when either the AUDIO button is pressed or
when playing 192 kHz source materila.
Notes
• On DVDs that contain copy protection, the 96 kHz signal
may only be output from the analog audio jacks. When this
type of disc is encountered, even if [Down Sample Off] is
selected, the player automatically outputs the digital audio
signal at a compressed rate of 48 kHz or 44.1 kHz.
• Changes to the [Linear PCM Out] setting cannot be made
when a disc is playing.
ADJUSTING AUDIO AND VIDEO SETTINGS