Filter
Top Products
43
6. IDE Hard Disk Installation
Usually, the unit comes with one hard disk drive installed in compartment HD 1, which is
default-configured as a master. The jumper settings configuration of the installed hard disk drives for
the unit and compatible drives which can be used with this unit are listed in the table below. To install
two hard disk drives in compartment HD 1 and HD 2, please use the following steps.
The jumper settings of hard disk drives for the system
Location Jumper
IDE 1 Compartment HD 1 Master
IDE 2 Compartment HD 2 Master
6.1 Built-in Hard Disk
1.
1. Unscrew all of
the mounting screws on
the mobile rack of the unit and detach it.
2.
3.
2.
Carefully lift the mobile rack to a vertical
position.
3.
Unscrew the secured screws to detach
the hard disk rack.
4.
5.
4.
Set the jumper of your hard disk driver.
The way to set the jumper of the drive
varies between manufacturers; please
refer to the instructions on the driver to
set the jumpers in the master position.
5. Place the hard disk in the rack.