Filter
Top Products
44
6.
6. Secure the driver in the rack using two
mounting screws in both the
side-mounting holes. Please don’t
tighten the screws too much, otherwise
that may damage the driver.
7.
8.
7. Screw the rack into the device,
screwing in all the four screws.
8. Attach
the interface connector and the
power connector to the drive. Please
note the red lining of the IDE cable
must be facing the 4-
pin power
connector.
10.
Place the mobile rack back onto the device and screw it in.
6.2 Mobile Rack
1. Make sure that the key is unlocked.
2. Pull the active-handle outward to remove the carrier body away from
the mobile rack.