Filter
Top Products
49
8. O.S.D Message
No. O.S.D Message Meanings
1 NO DISK No hard disk detected after power acti vated
2 BATTERY LOW Suggest change of battery and reset the system time
3 LOADING System Boot up
4 VIDEO LOSS Video loss
5 VIDEO IN Video input source
6 KEY LOCKED Key lock function is on
7 KEY UNLOCKED Key lock function is off
8 n1 OF n2 ITEMS PROGRESS n3 %
BACKUP n1/n2 NOW
9 BACKUP COMPLETE Backup complete
10 HD2 SPACE NOT ENOUGH HD2 has not enough space for backup
11 NO ENTRY FOR BACKUP No backup is possible.
12 BACKUP INCOMPLETE
Backup incomplete, since the user has pressed the
STOP
button to stop it
13 NOT FOUND The system cannot find a video in the Search function.
14 END Playback of recorded video has reached the end point
15 DISK FULL
Hard disks are full; this happens only when the DISK FULL
item in the setup menu is set to STOP.
16 EMPTY
The user presses the PLAY button
or uses the SEARCH
function, but no video can be played.
17 SET TO NTSC, PLS RESTART System has to be set to NTSC, please reboot
18 SOFTWARE UPDATE Software update
19 PLEASE RESTART
The system should be rebooted afte
r the software has
been updated
20 NO DISK
The user has pressed the Save key without putting in a
SD
card, or there is a disk error.
21 DATA NOT CONTINUOUS
The system finds data in installed HDs cannot be used
contiguously. Suggest you remove HD2 from the system.
22 DISK ATTACHED HD2 has been attached.
23 DISK REMOVED HD2 has been removed.
24 FAN STOPPED The chassis fan has stopped for over 30 seconds.
25 HDn ERROR AT xxxxx
There is a hard disk error during recording, where n is the
hard disk number and xxxxx is the hexadecimal location.
26 NOT PRESENT
When the user tries to clear a disk that was not attached in
the setup menu.
27 SAVE TO DISK Start saving to the JPEG file.
28 SAVE TO Fnnn. JPG Save to Fnnn. JPG (where nnn= 0..999)
29 SAVE OK Save to the JEPG is ok.
30 SD CARD WRITE PROTECT An SD card is write-protected; or there is an error