Filter
Top Products
13
Loading a Tape
Tapes can be loaded into your VCR as long as the VCR is plugged in. Even when
the VCR POWER is off, loading a tape will automatically turn the VCR on. Use
only tapes that have a , or label.
1 Hold the tape so that the long narrow edge with the contents label faces you.
The other edge is hinged and should face the VCR. The plastic window that
shows the videotape should face up.
2 Gently insert the tape evenly into the cassette slot until the VCR automatically
takes it in.
If the VCR will not automatically take the tape in, press EJECT and try again.
Your VCR will eject the tape if it is loaded improperly. If the VCR ejects the tape,
remove the tape, check to see that the contents label is facing you, that the geared
tape reels are facing down, wait a few seconds, and try again.
Playing a Tape
Playing a Tape Recorded in D-VHS Format
1 When you connect an integrated HDTV or IEEE 1394-equipped HDTV receiver
which is capable of controlling the VCR:
Operate your TV or receiver to playback the tape. Refer to the TV or receiver
owner’s guide for this procedure.
When you connect an integrated HDTV or IEEE 1394-equipped HDTV receiver
which is not capable of controlling the VCR:
Set the connection setting of your TV or receiver to select the HS-HD1100U.
Refer to the TV or receiver owner’s guide for this procedure.
And then press PLAY on the front panel or the remote control of the VCR.
You can stop playing by pressing STOP.
It will take a few seconds to display the playback picture. A mosaic noise, still or
black picture will appear until the correct picture comes on. When the VCR
reaches the end of the tape, it will automatically rewind to the beginning of the tape
and stop.
When you playback the end of a recording, the point where the recording mode
changes or a broken part of the tape, a mosaic noise, still or black picture may
appear.
The tape recorded in D-VHS format on other VCR may not be played back
correctly on this VCR.
Playing a Tape Recorded in Analog Format
1 Press PLAY on the front panel or the remote control.
The VCR will automatically play the tape at the correct speed. When the VCR
reaches the end of the tape, it will automatically rewind to the beginning of the tape
and stop.
You can stop playing by pressing STOP.
You can playback a tape recorded in S-VHS format with standard VHS resolution
(S-VHS quasi playback). This feature functions only during playback. You cannot
obtain the original resolution of S-VHS.
Depending on the tapes you are using, some interference may appear on the
screen during S-VHS quasi playback.
CORRECT
INCORRECT
213
546
879
0
STOP
PLAY
PLAY
STOP
Playback