Mitsubishi Electronics HS-HD1100U VCR User Manual


 
57
Trouble Checks
If your VCR malfunctions, try the following steps prior to contacting your Mitsubishi Dealer:
1 Check the Trouble Checks below to see if there is a solution to the current problem that you are experiencing.
2 If the problem is not addressed on the Trouble Checks, the safety circuits in the VCR may be in operation, thus
please try the following: (the clock setting and the timer recording will be deleted.)
1 If possible, press EJECT on the front panel and remove the tape.
2 Press TIMER RESET on the rear panel with a pencil or a ball point pen.
3 If a tape is not loaded, press POWER to turn the power on. If a tape is loaded, wait about 1 minute until the
tape protecting function is complete, then press POWER.
3 You may also try the following procedure if the above steps did not resolve the problem (All settings will be reset to
the default settings.).
1 Press POWER on the front panel for about 8 seconds until “ ” appears on the front panel display.
2 If a tape is not loaded, press POWER to turn the power on. If a tape is loaded, the tape protecting function will
work and “99” will appear on the front pane display to begin count down. Wait about 1 minute until it reaches
“00” to show the tape protecting function is complete, then press POWER.
If the problem with your VCR persists, contact your Mitsubishi dealer for assistance.
Try This...
Check the power cord and the AC outlet.
Is the LOCK light ON? If so, press and hold DISPLAY on the remote
for more than 8 seconds until the LOCK light turns off.
Is the LOCK light ON? If so, press and hold DISPLAY on the remote
for more than 8 seconds until the LOCK light turns off.
Set the VCR/TV slide switch to VCR position.
Press TIMER RESET on the rear panel.
Check the TV’s input setting.
Check to see that your VCR is not set to L1 or L2.
Check to see if your TV is set to the correct channel or input.
Check your TV’s fine tuning, if using an older TV.
Check your connections to make sure they are secure.
Check the erasure prevention tab on the tape cassette.
Check the hook-up.
Check to see if your TV is set to the correct channel or input.
Check the VCR tuning.
Check the input selection on the VCR. Does the front panel display
show L1 or L2? If so, switch it to tuner by pressing INPUT.
Check that the programmed recording light lights up on the front panel
display.
Check the clock time.
Make sure you have turned the VCR off before the start time.
For D-VHS timer recording:
- Check the IEEE 1394 connection.
- Is an integrated HDTV or an IEEE 1394-equipped HDTV receiver
turned on?
- Have you programmed the timer recording on an integrated
HDTV or an IEEE 1394-equipped HDTV receiver?
- The program prohibited from copying cannot be recorded.
Check the tracking control. Adjust manually if necessary.
Check the monitor settings.
Check the quality of the video tape.
Problem
The VCR won’t turn on.
The VCR power is on but no controls work.
You can’t see the VCR’s picture on your TV.
Poor picture when watching the VCR’s
tuner on your TV.
VCR REC button doesn’t function.
No picture during recording.
VCR does not record TV program.
The VCR timer recording does not operate.
Noise in the picture and distorted sound.
Poor or no Hi-Fi sound.