Filter
Top Products
23
Using One-Touch Recording (OTR)
One-Touch Recording (OTR) is a way to begin recording immediately and have
your VCR stop recording and turn off automatically after your show is over.
1 When you record a digital broadcast in D-VHS (digital) format, follow the steps
1 to 4 on page 20. And then press IEEE 1394 INPUT on the VCR remote
control to select the device you would like to record from. d1 to d5 will appear
on the front panel display. Select the number that corresponds to the device
from which you would like to record.
When you record a digital broadcast in VHS (analog) format, follow the steps 1
to 4 on page 21.
When you record an analog broadcast in VHS (analog) format, follow the steps
1 to 4 on page 22.
2 Press REC/˙REC LENGTH on the front panel twice. The first time you press
the button, recording will begin. The second press of the same button adds 30
minutes to the OTR timer, displayed on the front panel.
3 Press REC/˙REC LENGTH for each additional 30 minutes you want to add to
the OTR timer, up to 4 hours. If you press REC/˙REC LENGTH 10 times, you
will see End on the front panel display. The VCR will record until the end of the
tape. If you press REC/˙REC LENGTH an eleventh time, the VCR will
resume normal manual recording.
The OTR timer will begin to count down backwards. When it reaches zero, the
VCR will stop recording and turn off. The OTR light on the front panel display will
light up during the OTR recording.
If you program too much time into the OTR timer
Continue pressing REC/˙REC LENGTH. After the End point you can start over
from zero, adding time in 30 minute intervals.
How OTR affects other controls
If you press PAUSE during OTR, the VCR will pause recording, but the OTR timer
continues to count down.
Press PAUSE again to resume recording from the record-pause mode. The REC/
˙REC LENGTH will not resume your recording.
If you press STOP during OTR, you erase the OTR programming.
213
546
879
0
JOG/CHANNEL
SP/EP
REC
2 REC LENGTH
CHANNEL
INPUT
SP/EP
Recording