51
To program the remote control operational setting
The HS-HD1100U has two remote control operational settings, VCR-A and VCR-B.
These are available so you may separately control two Mitsubishi VCRs that are
placed close together. The VCR-A setting can be used to operate any other
Mitsubishi VCR introduced since 1986. Setting the HS-HD1100U to VCR-B will
allow the HS-HD1100U be operated without the VCR responding at the same time.
To program the HS-HD1100U and the remote to VCR-B
For VCR:
1 Make sure the HS-HD1100U is plugged in but turned off. On the VCR front
panel, turn the shuttle ring left while holding down SP/EP on the front panel. To
confirm that the VCR responds to VCR-B signals, b appears on the front panel
display.
For remote:
2 On the remote, make sure the VCR/TV slide switch is in the VCR position, then
press VCR/TV and number “2” at the same time. The remote will now send
VCR-B signals.
When you wish to operate the other VCR
1 On the remote, with the VCR/TV slide switch in the VCR position, press VCR/
TV and the number “1” at the same time. The remote will now send VCR-A
signals.
To reprogram the HS-HD1100U to respond to VCR-A signals again
1 Make sure the HS-HD1100U is plugged in but turned off. On the VCR front
panel, turn the shuttle ring right while holding down SP/EP on the front panel.
To confirm that the VCR responds to VCR-A signals, A appears on the front
panel display.
IMPORTANT
Some other models of Mitsubishi VCRs can respond to VCR-B signals. If
your other VCR is one of these models, and you would like to program the
other VCR to respond to VCR-B signals, refer to the owner’s guide that came
with the other VCR.
Some of the buttons may not function or they may operate different features
than expected for the other VCR, particularly, those Mitsubishi VCR’s that are
more than 10 years old because Mitsubishi changes the codes from time to
time.
Child Lock
The child lock feature prevents others from using your VCR. To lock the VCR:
1 Press and hold down DISPLAY on the remote control for about 8 seconds. The
LOCK light on the front panel display will light up.
2 To cancel the child lock, press and hold down DISPLAY for about 8 seconds,
until the LOCK light on the front panel display goes out.
IMPORTANT
You can lock the VCR with the power off, even if the VCR is standing by for a
programmed recording. If you lock the VCR with no cassette in it, the VCR
will not accept a cassette.
Advanced Features
PWR.
SP
CH
LOCK
VCR
REC
HMS
L
R
LOCK light
213
546
879
0
2
VCR/TV
1
shuttle ring
VCR-AVCR-B
SP/EP