Mitsubishi Electronics HS-HD1100U VCR User Manual


 
37
Cancelling a Timer Recording before the Recording Starts
1 Press MENU on the remote control. Your VCR will turn on and VCR Main
Menu will appear on your screen. Press the ADJUST buttons on the remote
control to select Program to record. Press ENTER.
2 Recap screen will display for 4 seconds. While this screen is displayed, press
the ADJUST buttons to place the cursor next to the program you wish to
cancel.
3 Press CANCEL. The program is erased.
4 Press MENU twice to turn off the menus.
TIMER RESET
You can use TIMER RESET on the rear panel to erase both the clock and all timer
recordings.
To use TIMER RESET, press it with a pencil or a ball point pen. The power will turn
off and the clock will be cleared. All timer recordings are erased.
If you have set the Auto clock set setting of the Set the clock menu to ON, the auto
clock function will automatically set the clock again.
Memory Backup
If the VCR is without power for 30 minutes or less, it will retain the clock and the
programmed settings. The VCR must have been plugged in for at least an hour
beforehand to charge this backup. If the power is lost for more than 30 minutes,
the time and the programmed settings will be lost.
If you have set the Auto clock set setting of the Set the clock menu to ON, the auto
clock function will automatically set the clock again when power is restored.
VCR Rear Panel
TIMER
RESET
TIMER
RESET
¬Program to record
CH DAY ON OFF
§ 2 MO11 11:30am 1:30pm SP
--- -- --:-- --:-- SP
--- -- --:-- --:-- SP
--- -- --:-- --:-- SP
∫πMENU to go back
∂ ππADJUST to select
≤¥≥πENTER to enter
∑ ππADJUST to select
Recap screen
Timer Recording