32
IMPORTANT
If you press ENTER when you set the timer recording incompletely, Current
Program is not completed will appear on your screen.
If two programmed recording times overlap, VCR is already programmed for
that time will display on your screen for about 3 seconds, and then the Recap
screen will appear. The program you have just set will be highlighted in
magenta color and flash for 3 seconds. The start and stop time of the
overlapped program will be highlighted in cyan color. You will need to erase
one of them.
10 The programmed memory will appear on the Recap screen.
11 To program additional recording times, select an empty program line by
pressing ADJUST buttons. Press ENTER. The VCR Plus+ system menu will
appear. Continue the programming procedure from step 3.
12 When you are finished entering the programs you wish to record, check the
following:
• If you have a cable box, leave the box tuned to the station you wish to
record.
• Turn the VCR power OFF and make sure the programmed recording light is
lit.
IMPORTANT
When programmed recordings of 4 and under are entered, only 4 of the 8
program lines appear on the Recap screen at any one time. To see
additional program lines, press the ADJUST buttons to scroll the lines on the
screen.
Cancelling a Recording in Progress
There are two ways to cancel a recording in progress:
Press STOP. The recording stops, but the program is not cancelled.
Therefore, if you press REC, the recording will start again.
Press POWER on the front panel. The recording stops and the program is
cancelled.
Changing while Programming
To change one of your settings (such as start time) while you are programming:
Press ENTER to move forward through the program list.
Press CANCEL to move backward.
Then use the ADJUST buttons to change the setting.
You will cancel the entire program if you press CANCEL while the channel number
is flashing.
Recap screen
¬Program to record
CH DAY ON OFF
10 TH14 9:00pm 10:30pm SP
§ 2 MO11 11:30am 1:30pm SP
--- -- --:-- --:-- SP
--- -- --:-- --:-- SP
∫πMENU to go back
∂ ππADJUST to select
≤¥≥πENTER to enter
∑ ππADJUST to select
879
0
ADJUST
ADJUST
ENTER
CANCEL
forward
backward
adjust
POWER
879
0
STOP
STOP
Programming not cancelled
Programming cancelled
Timer Recording