Mitsubishi Electronics HS-HD1100U VCR User Manual


 
40
Copying a Tape from Analog to Analog
There are two basic ways to make a copy of a tape from analog to analog.
One way is to use the HS-HD1100U to record and another VCR for playback.
The other way is to use another VCR to record and use the HS-HD1100U for playback.
Regardless of which method you may choose, you will need one RCA audio cable and video cable to connect the two
VCRs. If you do not have these cables, they are available at your local electronics dealer.
IN
1
AUDIO
VIDEO
IN
1
L/MONO
R
L
R
L
R
HS-HD1100U RECORDING PLAYBACK
VIDEO IN
AUDIO IN R
AUDIO IN L
AUDIO OUT L
VIDEO OUT
AUDIO OUT R
Using the HS-HD1100U to Record from Another VCR
1 Connect the audio cable to AUDIO OUT L and R on
the playback VCR and to AUDIO IN L and R on the
HS-HD1100U. If the playback VCR is mono, use
only the AUDIO IN L on the HS-HD1100U.
2 Connect a video cable to VIDEO OUT on the playback
VCR and to the VIDEO IN on the HS-HD1100U.
3 If the playback VCR is Hi-Fi, set the audio monitor to
Stereo.
4 Use INPUT to set the HS-HD1100U to External L1
(L1) if you used the HS-HD1100U rear panel jacks,
or External L2 (L2) if you used the HS-HD1100U
front panel jacks.
5 Put a blank tape into the HS-HD1100U.
6 Put the tape you want to copy into the playback VCR
and find the cue point. Press STOP if the picture
starts playing.
7 On the HS-HD1100U, press REC, then PAUSE.
8 On the playback VCR, press PLAY, then PAUSE.
9 Press the PAUSE buttons on both VCRs at the same
time to begin copying the tape.
10 When finished, press STOP on both VCRs.
Editing Features