Mitsubishi Electronics LT-46153 Flat Panel Television User Manual


  Open as PDF
of 96
 
1. Basic Setup and Operation 13
About Auto Input Sensing/
Auto Output Sensing
ThisTV’sEasyConnect™AutoInputSensingfeature
detectsmostconnectionsautomatically.Theexcep-
tionsare:
Aconnectiononthe•
ANT
input
AnHDMIdevicethatispoweredoff.Poweron•
thedevicetoensuredetection.
Auto Sensing for Most Devices
Whenyoufirstconnectadevice,theTVwill:
a. Detecttheconnecteddeviceandautomatically
switchtoit.
b. Promptyoutoidentifythedevicetype.
c. 153 and 249 Series.Promptyoutoperform
NetCommandset-upforthedevice,ifavailable.
d. Repeatthesestepsforanyothernewlydetected
devices.
When You First Connect a Device
Most Device Types.•
Selectthedevicetypefrom
theon-screenlist.Thedevicetypeyouselecthere
willappearasadeviceiconinthe
Activitymenu.
A/V Receiver•
TheTVdetectsaudioconnectionsonthe- DIGITAL
AUDIO OUTPUTjackandtheright(red)AVR
AUDIO OUTPUTjack.
ForanHDMIA/Vreceiver,select- AVRfrom
thelistofdevicetypesiftheA/Vreceiveris
notrecognizedautomatically.
HDMI CEC Devices Compatible with the TV’s •
HDMI Control Feature.
CompatibleCEC-
enabledHDMIdevicesareoftenrecognizedauto-
maticallybytheTV.
HDMIControlmayallowyou
tocontrolsomefunctionsofaCEC-enableddevice.
SeeAppendixB,“HDMIControlofCECDevices.”
New Device Found screen for a device with HDMI
control enabled. Select On to enable the TV’s CEC
control of the device. In some cases, as in the
example above, you will also be prompted to select a
device name.
Tips on Auto Sensing
Chooseadifferentnameforeachinput.•
Theantennainput(•
ANT
)isneverdetected,
althoughyoucanturnofftheunusedantenna
inputintheInputs>Namemenu.
Changethedevicetypedisplayedinthe• Activity
menuintheInputs > Namemenu(page50).You
mustswitchtoadifferentinputbeforechanging
thedevicetype.
153 and 249 Series.• Any“learned”NetCom-
mandIRcodeswillbeerasedifyouchangethe
devicetypeintheInputs > Namemenu.
Reactivating Auto Sensing for an HDMI Input
WhenyoudisconnectanHDMIdevice,AutoSensingis
disableduntilyouperformthesesteps.
Switchtoanyinputotherthantheonetobedis-1.
connected.
DisconnecttheHDMIdevice.2.
DeletetheremovedHDMIdeviceinthe3. Inputs>
Namemenu(see“RemovinganHDMIDevice,”
page77).
ConnectthenewHDMIdeviceandthe4. New
Device Foundscreenwilldisplay.
Setting Up TV Inputs, continued
Downloaded From TV-Manual.com Manuals
 previous next