Filter
Top Products
21
Adding and Deleting Channels
If necessary, you can manually add or delete channels after you have completed
the automatic channel memorizing by using ALLSET. You cannot do this for chan-
nels coming from a satellite receiver.
1 Make sure that video mute is ON. See page 60.
2 Set the VCR’s input to tuner. To do this, press INPUT on the remote control
until a channel number appears on the screen or the front panel display.
3 Press MENU on the remote control. VCR Main Menu appears.
4 Turn the ADJUST dial on the remote control to select First Time Set-Up. Turn
the SHUTTLE ring to the right.
5 You will see the First Time Set-Up menu. Turn the ADJUST dial to select Add/
delete channels. Turn the SHUTTLE ring to the right.
IMPORTANT
If you are recording, playing back a tape, receiving a video signal from an
external input, or watching a satellite receiver channel, then Not available will
flash on-screen. To correct this, stop the tape or turn off the menus and
switch the VCR’s input to tuner.
6 You will see the screen for adding or deleting channels. Use the ADJUST dial
to select the channel that you want to add or delete. Press ENTER or turn the
SHUTTLE ring to the right to add the channel; press CANCEL or turn the
SHUTTLE ring to the left to delete it.
7 When you are finished adding or deleting channels, press MENU three times to
exit the menus.
IMPORTANT
If you use ALLSET to memorize channels again, you will lose all of the
manual changes you made. All of the channels you deleted will be added; all
of the channels you added will be deleted. If your cable box receives only
one or two digit channels, you cannot add a three-digit channel.
Setting Up Your VCR
«Add/delete channels
Channel 39
Not in memory
Use ADJUST to select
a channel. Use ENTER
to add it, CANCEL to
delete it.
Press MENU to go back.
ƒFirst Time Set-Up
∆AllSet
≈Set the clock
«Add/delete channels
±Sat.receiver (OFF)
ππππππππππππππππππππππππ
Use ADJUST to select,
and ENTER.
Press MENU to go back.