Filter
Top Products
37
Mitsubishi offers 6 ways to set your VCR to record upcoming broadcasts. Choose
from:
D-VHS Timer Recording
Analog Timer Recording of Digital Broadcast
VCR Plus+ system programming (easy)
On LCD programming
Conventional VCR timer recording
Quick Program (easy) -- VCR does not need to be on to begin programming
You can schedule up to 8 recording events within a one month period.
Clock must be set before any timer recordings can be performed.
D-VHS Timer Recording
To set the timer recording of the digital broadcast in D-VHS format, set the timer
recording on the integrated HDTV or on the IEEE 1394-equipped HDTV receiver,
not on the VCR. Refer to your TV or receiver owner’s guide.
1 Follow the steps 1 to 4 of Setting Up Your VCR to Playback/Recording the
Digital Broadcast in D-VHS format on page 12.
2 Load a D-VHS tape with its erasure prevention tab intact into the VCR.
3 Make sure that the D-VHS button on the front panel is lit. If not, press this
button until it lights up.
4 Press POWER on the VCR front panel or on the remote control to turn off the
VCR.
5 Set the timer recording on the integrated HDTV or on the IEEE 1394-equipped
HDTV receiver. Refer to your TV or receiver owner’s guide for this procedure.
The integrated HDTV or the IEEE 1394-equipped HDTV receiver will receive the
program to be recorded on the start time you have set and send the signal to start
recording to the VCR. The VCR will start recording automatically. The integrated
HDTV or the IEEE 1394-equipped HDTV receiver will send the signal to stop
recording to the VCR on the end time you have set, and the VCR will stop record-
ing automatically.
IMPORTANT
The recording mode will be changed automatically depending on the
broadcasting signal.
Depending on your integrated HDTV or IEEE 1394-equipped HDTV receiver,
the programmed D-VHS recording may not be recorded if you turn on the
VCR while it is in stand-by mode for the D-VHS timer recording.
The programmed D-VHS timer recording may not be recorded correctly
depending on your integrated HDTV or IEEE 1394-equipped HDTV receiver.
When you connect more than one integrated HDTVs or IEEE 1394-equipped
HDTV receivers, the D-VHS timer recording of only one integrated HDTV or
IEEE 1394-equipped HDTV receiver will be activated. In this case, while the
VCR is in stand-by mode for the D-VHS timer recording, press INPUT on the
VCR remote to set the VCR’s input to the tuner or press IEEE 1394 INPUT to
select d1 to d5 which corresponds to the receiver or the TV from which you
would like to record.
Timer Recording