Filter
Top Products
50
Timer Recording
Cancelling a Timer Recording before the Recording Starts
1 Press MENU on the remote control. Your VCR will turn on and VCR Main
Menu will appear on your screen. Turn the ADJUST dial on the remote control
to select Program to record. Turn the SHUTTLE ring to the right.
2 Recap screen will display for 4 seconds. While this screen is displayed, turn
the ADJUST dial to place the cursor next to the program you wish to cancel.
3 Press CANCEL. The program is erased.
4 Press MENU twice to turn off the menus.
Using a Satellite Receiver
If you are using a Mitsubishi, Panasonic, RCA, Sony, Toshiba, or Hughes satellite
receiver, your VCR will automatically turn the receiver on when a timer recording
begins and off when the recording ends.
However, if you are using a PRIMESTAR
®
or DISH Network
™
receiver, you will have
to turn the receiver on before a timer recording begins.
Before turning off the VCR, to put your VCR in stand-by for recording, make sure
that your satellite receiver’s menu turns off.
You can watch satellite channels through your VCR even when the VCR is turned
off but only if you connected your VCR and TV with an S-Video cable and the Rear
S-through in the S-VHS Set-Up menu is set to ON. If you used a standard video
cable, you can only view satellite channels through your VCR when the VCR is on.
TIMER RESET
You can use TIMER RESET on the rear panel to erase both the clock and all timer
recordings.
To use TIMER RESET, press it with a pencil or a ball point pen. The power will turn
off and the clock will be cleared. All timer recordings are erased.
If you have set the Clock set setting of the Set the clock menu to AUTO, the auto
clock function will automatically set the clock again.
Memory Backup
If the VCR is without power for 30 minutes or less, it will retain the clock and the
programmed settings. The VCR must have been plugged in for at least an hour
beforehand to charge this backup. If the power is lost for more than 30 minutes,
the time and the programmed settings will be lost.
If you have set the Clock set setting of the Set the clock menu to AUTO, the auto
clock function will automatically set the clock again when power is restored.
TIMER RESET
VCR Rear Panel
TIMER RESET
¬Program to record
CH DAY ON OFF
§ 2 MO12 11:30a 1:30pSP
--- -- --:-- --:-- SP
--- -- --:-- --:-- SP
--- -- --:-- --:-- SP
ππππππππππππππππππππππππ
Use ADJUST to select,
and ENTER.
Press MENU to go back.
Recap screen