Filter
Top Products
41
9 Turn the ADJUST dial to set the recording speed:
SP = standard play; EP = extended play; AUTO = auto. Auto speed
programming is discussed on page 48. Turn the SHUTTLE ring to the right.
IMPORTANT
If you turn the SHUTTLE ring to the right when you set the timer recording
incompletely, Program is not completed will appear on your screen.
If two programmed recording times overlap, VCR is already programmed for
that time will display on your screen for about 3 seconds, and then the Recap
screen will appear. The program you have just set will flash for 3 seconds
and the start time and the stop time will be shown in red letters. The start
and stop time of the overlapped program will be highlighted in red color. You
will need to erase one of them.
10 The programmed memory will appear on the Recap screen. “S” next to the
channel number indicates satellite channels.
11 To program additional recording times, select an empty program line by turning
ADJUST dial. Turn the SHUTTLE ring to the right. The VCR Plus+ system
menu will appear. Continue the programming procedure from step 3.
12 When you are finished entering the programs you wish to record, check the
following:
• If you have a cable box, a digital cable box, a PRIMESTAR
®
or a DISH
Network
™
satellite receiver, leave the cable box or receiver turned ON.
• If your VCR does not control your cable box, leave the box tuned to the
station you wish to record.
• Turn the VCR power OFF and make sure the programmed recording light is
lit.
IMPORTANT
When programmed recordings of 4 and under are entered, only 4 of the 8
program lines appear on the Recap screen at any one time. To see
additional program lines, turn the ADJUST dial to scroll the lines on the
screen.
Cancelling a Recording in Progress
There are two ways to cancel a recording in progress:
Press STOP. The recording stops, but the program is not cancelled. There-
fore, if you press REC, the recording will start again.
Press POWER on the front panel. The recording stops and the program is
cancelled.
Changing while Programming
To change one of your settings (such as start time) while you are programming:
Turn the SHUTTLE ring to the right to move forward through the program list.
Turn the SHUTTLE ring to the left to move backward.
Then use ADJUST dial to change the setting.
You will cancel the entire program if you turn the shuttle ring to the left while the
channel number is flashing.
¬Program to record
ƒChannel 2
ƒDay Monday 12
ƒStart time 11:30am
ƒStop time 1:30pm
ƒRecord speed SP
ππππππππππππππππππππππππ
Use ADJUST to select,
and ENTER.
Press MENU to go back.
Recap screen
¬Program to record
CH DAY ON OFF
10 TH15 9:00p10:30pSP
§ 2 MO12 11:30a 1:30pSP
--- -- --:-- --:-- SP
--- -- --:-- --:-- SP
ππππππππππππππππππππππππ
Use ADJUST to select,
and ENTER.
Press MENU to go back.
forward
shuttle ring
ADJUST
backward
POWER
STOP
STOP
Programming not cancelled
Programming cancelled
Timer Recording