Filter
Top Products
35
Changing the Extender ID
1. Make sure the Extender ID button is active.
The button is active when the button label
is white.
2. Press the + and – action buttons to change
the Extender ID.
The remote controller offers 16 Extender
ID’s.
Getting the Maximum out of it
5. Tap Accept to save the RF IR settings
for the selected device.
or
Tap Cancel to return without
changing the RF IR settings for the
selected device.
6. Repeat instructions 3 to 5 for all
devices for which you want to change
the RF IR settings.
7. Tap Close.
The remote controller switches back to Use
mode. The remote controller is configured to
operate the devices you have set with RF
signals.
8. Try the devices which you just
changed the RF IR settings.
Note:
There is a possibility that a device does not
respond properly when operated with RF signals.
This is mostly due to IR signals that cannot be
properly transmitted as RF signals.
In that case, you have to reconfigure the remote
controller to operate the device with IR signals
again.